Water Sensor 7 Pro

Flood Sensor. Leak Sensor.

It’s the building block of life. It’s also the building block of expensive bills and costly damage when it ends up where it shouldn’t.

Temperature-
sensor

Humidity-
sensor

Tamper
protection

Leak detection.

What comes up. If it were only a leak detector, we wouldn’t call it Water Sensor 7 Pro. Monitoring more than just the presence of liquid, this pro sensor earns its name through its ability to also monitor the absence of water. When used to monitor tanks or pits, Water Sensor 7 Pro can alert you when water levels get too low and can also trigger automation routines.

Sensor cable measures 1.5m / 4.9ft

Leaks & bursts.

Water Sensor 7 Pro’s stainless-steel detection-tip can detect minuscule amounts of water – as little as 0.5mm / 0.02” on a surface – making it your first line of defence against damaged and faulty plumbing.

Floods.

Whether a small amount or large, Water Sensor 7 Pro also is perfect at monitoring for the accumulations and floods that you can anticipate, such as sump basins and in wet areas.

Overflows.

Accidents happen but that doesn’t make the damage caused by forgotten taps any less expensive. Water Sensor 7 Pro can alert you to the water you’ve forgotten to turn off before it’s too late.

Leak protection.

It doesn’t just monitor for when water goes wrong. Once connected to a Z-Wave automation system, Water Sensor 7 Pro can take protective measures to help limit the amount of damage caused by drips, leaks, bursts or other water flow.

Auto-close water valves.

In the event of a pipe burst, Water Sensor 7 Pro can instruct water valves, including those installed on the mains, to automatically close.

Turn on sump pumps.

When water levels are detected to be too high or low, turn electronic pumps or sump pumps and run them for a defined period of time or till the desirable water level is reached.

Auto turn off power

Water and electricity don’t mix. In the event of a leak or flood protect your home and family by turning off connected-electronics, such as those plugged into Smart Switch 7.

Quality Foundation.

Water Sensor 7 Pro’s accuracy, reliability, and compatibility begin at its very foundation. With its leak processor sized at only 70x30mm (2.8×1.9in), it has been built atop of Aeotec’s exclusive Gen7 technology enabling it to be wireless installed almost anywhere in a room and to operate for 3 years before its single, 3.6 volt battery needs changing.

For more information:

Control doesn`t stop here.

Aeotec’s range of intelligent, automation controllers doesn’t end here. From smart plugs to wireless wall switches and water sensors, it’s a range that keeps you in control and ensures that automation systems are always an intelligent enhancement.